Changing The Printing Origin - MIMAKI TS500P-3200 Operation Manual

5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
7
Press the
• The media selection screen is displayed.
8
Press the to select "LEAF" .
9
The media detection is started.
(1) The media width is detected.
(2) It returns to the LOCAL when the detection is
completed.
key.

Changing the printing origin

The position of the printing origin can be changed.
1
In Local, Press
• It enters into the origin setting mode.
2
Press
to a desired position.
• Select the carriage and media, moving the point
with [][][][].
• When you press [FUNC2](CUT) here, you can
perform media cutting.
Set Origin
X Position
0.0
Origin
(Length)
3
After determining the origin, press the
key.
• The printing origin is changed.
Typical setting position of printing
origin
The printing origin in the depth direction (X') is positioned
at about 75 mm rearward from the slot for cutting on the
platen. The printing origin in the scanning direction (Y') is
positioned at 15 mm from the right end of the media. The
value in the scanning direction (Y') can be changed using
[MARGIN] in Setup menu. (
This can be changed by using the Jog key.
slot for cutting
approx. 75 mm (X')
.
to set the origin
Y Position
0.0
Origin
(Width)
P.3-9)
15 mm
(Y')
2-15
2
2
2
2