Table of Contents
Advertisement
Changing an ink bottle
Perform as follows when [INK END] or [INK NEAR END] is displayed on the display.
When [INK END] is displayed
1
Remove the ink cover of the ink bottle to be
changed, and remove the empty (used) ink bottle.
• Transfer any remaining ink into the new bottle. Make sure
that no ink spills out from the ink bottle while doing so.
• When replacing the ink bottle, ink may spatter. Be careful
not to get ink into your eyes.
• Before replacing the ink bottle, cover around it with a
waste cloth etc. Ink may drop from the float part and may
stain around the part.
2
Check the up/ down movement of the float.
• If there is an abnormality on the float movement because dry ink
adhered to it etc., perform the following procedures:
(1) Place a few drops of washing liquid on the upper part
of the
float.
(2) Move the float up/ down to spread washing liquid
evenly.
(3) When the float comes to move smoothly, wipe
washing liquid adhering to the float and the pipe with a
waste cloth etc.
• Move the float up/ down again and check that there is
no abnormality.
3
Remove the cap of the new ink bottle, make slits in
the top surface of the bottle as shown in the figure,
and push the aluminum sheet downward.
• For the way to make slits in the aluminum sheet, refer to the
Step 4 of "Setting ink bottles" (
1-20
P.1-18).
Setting ink bottles
Catches
Advertisement
Table of Contents
