Table of Contents
Advertisement
Setting ink bottles
Set the ink bottle on the external ink supply unit.
1
Remove the ink cover.
• Remove both catches of the ink cover and remove the
cover.
• The rear surface of the ink cover has the nozzle (stick
shape) for ink absorption and the float sensor for detecting
remaining amount of ink.
Float sensor
2
Put the removed ink cover on the ink cover of the rear surface side.
A part
ink cover catch
3
Take out the ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
Before shaking it, check that
the cap is firmly closed.
4
Remove the cap of the ink bottle.
B part
Hook A part of lower part
of the cover onto the rear
Handle
surface ink cover catch.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
Cover with paper towel firmly and shake ink slowly
Nozzle
Repeat this
Setting ink bottles
Catches
Hook B part of
cover rear surface
onto the handle at
the rear surface.
1-17
1
3
4
5
6
Advertisement
Table of Contents
