Table of Contents
Advertisement
Removing USB memory
If a USB memory module is inserted in the personal computer to which a Tx500 machine is connected, click
"Stop" in the "Safely Remove Hardware" window by following the instructions given there first and then remove
the module.
Leaving a USB memory module inserted can cause [ERROR 201 COMMAND ERROR].
Copy the data onto the hard disk before outputting it for printing.
Connecting Power Supply Cable
Connect the power cable to the distribution board with the following specifications.
Power voltage
Frequency
Capacity
• 100V system outlet cannot be used.
• You cannot perform the installation of this machine. Request an electrician for doing the installation
work.
• The following electrical work is required for power supply to the main body. Request an electrician for
the work.
Socket work to the breaker
C type grounding work (Special 3rd type grounding work)
• Make sure that the power breaker is placed close to the machine so that the power can be shut down
easily when necessary.
• Doing the electrical work of this machine by other than a person who has the license of the electrical
work is prohibited to prevent the electric shock.
• Be careful not to perform faulty wiring. It may cause fire or electric shock.
• Make sure to connect the power cable to the distribution board that is grounded. Otherwise, it may
cause electric shock or damage of this machine.
• Make sure that the power breaker supports the incoming currents of 50A/0.01 second and faster
before connecting.
1-16
AC380-420V ± 10%
50/60Hz ± 1Hz
20A and above
Advertisement
Table of Contents
