Changing The Printing Origin - MIMAKI JV300-130 A Operation Manual

Chapter 2 Basic Operation
Push down the clamp lever and close the
4
front cover.
• Set the media straight.
• Set the media on the black part of the platen so
that it comes out approximately 40mm. If it is
shorter than that, it may not be able to perform the
media detection.
Media
Press the
5
Press the
6
The media detection is started.
7
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.
Notes when using media press
• When installing the media, align the media's right
edge with the groove in the platen. Placing the
media rightward of the groove will make it rise up if
it moves obliquely, and this could cause damage
to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message "MEDIA SET
POSITION R" or is displayed. Set the media
again.
Groove
Media
2-8
Approximately
40mm
key.
key to select "LEAF" .
Media
Press

Changing the printing origin

The position of the printing origin can be changed.
Moving the LED pointer to the changing position and
deciding the position.
In Local, Press
1
• It enters into the origin setting mode.
Set a light point of the LED pointer to the
2
changing position by pressing
• Select the carriage and media, moving the point
with [][][][].
After determining the origin, press the
3
key.
• The printing origin is changed.
Typical setting position of printing
origin
The printing origin in the depth direction (X') is positioned
at about 75 mm rearward from the slot for cutting on the
platen. The printing origin in the scanning direction (Y') is
positioned at 15 mm from the right end of the media. The
value in the scanning direction (Y') can be changed using
[MARGIN] in FUNCTION mode. (
This can be changed by using the Jog key.
slot for cutting
approx. 75 mm(X')
.
.
P.3-8)
15 mm
(Y')