Table of Contents
Advertisement
Feed the media
1
Set it to the "MANUAL" screen by pressing
[MANUAL] on the operation touch panel.
2
Adjust the position of the feeding unit by rotating the [MANUAL CENTERING] lever
located on the rear surface control panel so that the unit is positioned at the center
almost of the centering range.
3
Set the media on the roll shaft.
(1) Rotate the roll shaft and make the roll shaft slot turn
up.
(2) Tilt the shaft fixing.
(3) Remove the roll shaft.
2-14
• Before moving the shaft fixing, be sure
to check that the roll shaft slot turns up.
If you move the shaft fixing with the roll
shaft slot turn down, the roll shaft may
fall off and it is very dangerous.
MENU
BELT
BELT HEATER
MANUAL
START BELT
OFF
SPEED %
POWER %
10
100
AUTOMATIC
ON
FEED
SETUP
PRESSURE ROLLER
WASHING UNIT
LOWER
OFF
SERVICE
WATER VALVE
AIR VALVE
AIR VALVE
ALARMS
MOTOR RUNNING
BRUSHER MOTOR
ABOUT
CENTERING UNIT
OFF
RESET
Shaft fixing
AIR BLADE
OFF
MOTOR RUNNING
TAKEUP UNIT
CLOCKWISE
TAKEUP MOTOR
DISCHARGE
MEDIA
STATE
ALARM
Advertisement
Table of Contents
