Table of Contents
Advertisement
SYSTEM HALT
Message
S Y S T EM H A L T
0 0 0 : ME S S A G E
X-unit Error
Message
EMERGENCY BUTTON
PRESSED
PLC BATTERY LOW
EMERGENCY ERROR
MEDIA END ERROR
MEDIA NEAR TO WASHING
UNIT
PRESSURE ROLLLER NOT
IN POSITION
LOW AIR PRESSURE
MAIN HEATER ALARM
COMMUNICATION ERROR
TAKE UP MOTOR INVERTER
FAULT
PRESSURE ROLLER MOTOR
INVERTER FAULT
BRUSHER MOTOR
INVERTER FAULT
BELT MOTOR INVERTER
FAULT
AIR BLADE UNIT MOTOR
FAULT
BELT HEATER FAULT
CENTERING UNIT MOTOR
FAULT
TAKE UP MOTOR FAN FAULT
Turn off the main power to the machine and turn it on after a while.
Check the number and contact your local distributor to call for service.
No.)
Cause
EMERGENCY button was pressed, or
electrical BOX cover opened.
It detected that PLC run out of battery.
There was abnormality in printer part.
media end function was active, but it
could not detect media.
It detected that media got closer to
washing unit.
Abnormality in pressure roller position
was detected.
Air pressure is less than 6 bar, and it is
not enough.
Media heater is not connected.
There was abnormality in communica-
tion between media feeding part and
printer part.
There was abnormality in take-up motor
inverter.
There was abnormality in pressure
roller motor inverter.
There was abnormality in washing
brush motor inverter.
There was abnormality in belt motor
inverter.
There was abnormality in air blade
blower.
There was abnormality in belt heater.
There was abnormality in centering
motor.
There was abnormality in take-up
motor.
Warning / Error Messages
Solution
Solution
• Please cancel EMERGENCY button, or
close electrical BOX cover.
• Please call our customer service or dealers.
• Please check the error message of the
printer part.
• Please check whether media end sensor is
set in correct position.
• Please perform cleaning of peeling sensor.
• Please check whether pressure roller stop-
per pin is not inserted.
Also, please check whether foreign sub-
stance is not pinched under the pressure
roller.
• Please check whether air is supplied.
• Please turn OFF all the power once, and
after a while, please turn ON.
If you want to show the message again,
please call our service engineer or dealers.
• Please check whether it does not become
overloaded with feeding unit.
Please turn OFF all the power once, and
after a while, please turn ON.
If you want to show the message again,
please call our service engineer or dealers.
• Please check whether it does not become
overloaded with take-up motor.
Please turn OFF all the power once, and
after a while, please turn ON.
If you want to show the message again,
please call our service engineer or dealers.
("000" is the error
1
1
1
1
5
5-19
Advertisement
Table of Contents
