MIMAKI Tx500-1800B Operation Manual page 140

5
Press
NOZZLE RECOVERY and press the
6
Register the Nozzle number that needs NOZZLE
RECOVERY and press the
(1)
Select the registration number from 1 to 10 by pressing
(2) Register the nozzle number that needs recovery by pressing
• If the registered nozzle cannot be recovered, the screen of
the Step 3 in P.4-21 "Check the print condition for which
nozzle recovery cannot be performed" is displayed.
Example of nozzle to be recovered
230
210
190
170
Nozzle missing
No.128
150
130
110
90
70
50
Nozzle
30
number
10
7
Press the
• Up to 10 nozzles can be registered per 1 nozzle line.
• Even if you use this function, time required for drawing does not change.
• In the minimum number of pass of the drawing mode, the NOZZLE RECOVERY function is not
available.
• In the minimum number of pass for double speed mode and normal speed mode, NOZZLE
RECOVERY function is not available.
• Even if you register the NOZZLE RECOVERY, the pattern of test print etc. is not recovered.
4-20
to select the Nozzle line that needs
and press the key.
and press the key.
221 Nozzle missing
No.184
201
181
161
141
121
101
81
Nozzle missing
No.16
61
41
21
1
key several times to end the setting.
key.
Head No.: H1 or H2
H 1 - A
key.
N o . 1 : 1 8 4
Registration No.: 1 to 10
Registration Recovery
number Nozzle No.
1 16
2 128
3 184
4 OFF
5 OFF
S E L EC T NOZ Z L E
: H 1 - A
Nozzle line: A,B,C,D
Recovery nozzle No.
(1 to 320) or OFF
State
Target for nozzle recovery
Target for nozzle recovery
Target for nozzle recovery
No registration
No registration