Table of Contents
Advertisement
6
Soak the clean stick or the waste cloth in the maintenance cleaning liquid and wipe off
an accumulated ink on the side of the head and on the bottom surface of the slider.
• Do not touch the nozzle surface, because the cleaning will be performed in the step 7.
Nozzle part
7
Soak the COTTON CIEGAL
the cap rubber attached on the nozzle surface from the rear side to the front side.
COTTON CIEGAL
8
Press the
• Close the left maintenance cover then press the
4-16
Side surface of the head (shown in deep gray)
Bottom surface of the slider
(shown in gray)
• Clean the wiper until it looks as shown in the
photo on the right.
®
in the maintenance cleaning liquid and wipe off the mark of
®
• Immerse much enough so that maintenance liquid may drip from it.
• Do not wipe the nozzle surface with dry COTTON CIEGAL
®
• If COTTON CIEGAL
has fluffed, replace it.
• If ink solid adheres to COTTON CIEGAL
replace it.
key after the cleaning.
Cleaning the Head and the Area around It
[Before cleaning]
®
.
®
, change the surface to use for cleaning or
COMP L E T ED
key.
[After cleaning]
Mark of the cap
C l o s e a c o v e r
[ EN T ]
Advertisement
Table of Contents
