12
After peeling off adhesive as much as possible
with the resin board, remove the remaining
adhesive on the belt surface with ethanol and
the waste cloth.
• After the work above is completed, recheck whether there is any adhesive left not being peeled or
large dust. If adhesive is newly coated with any adhesive left on the belt surface, concavity and
convexity are generated on that part and it may influence on printing result.
• After the belt surface is dehydrated, coat new adhesive. (next page)
• Perfuse gelled liquid including peeled remover onto a waste cloth etc. and discard after dehydrating it.
When power of adhesive weakened
1
2
3
4
6
4-37