Table of Contents
Advertisement
10
Clean the wiper blade.
• Soak the clean stick in the maintenance cleaning liquid, and
then remove the ink that has adhered to the wiper blade.
11
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
12
Press the
13
Close the right maintenance cover then press the
• After its initial operation, the machine returns to step1.
Performing the station maintenance without
You can select station maintenance by using the
key.
Press the
key in Local.
4-8
• Make sure to be careful with the edge of the
wiper blade, and thoroughly clean the side
(back side) where the wiper touches.
• Clean the wiper blade until it looks as shown
in the photo below.
• Clean the wiper until it
looks as shown in the
photo on the right.
• Make sure that the cap
rubber and mesh inside
the cap have not come
off after cleaning.
key after the cleaning.
Press
select [MAINTENANCE].
Cap rubber
MAINT.
key in the Local without pressing the
Press the
to
• It becomes the same condition as the
key is pressed from Local.
MAINT.
Wiper blade
Wiper blade
Cap rubber
cover
C l o s e a c o v e r
COMP L E T ED
[ EN T ]
key.
key
MAINT.
key twice.
Advertisement
Table of Contents
