Table of Contents
Advertisement
Detecting the Media
Media detection is a function for setting the printable area.
1
Press
select ROLL/LEAF.
• If "LEAF" is selected, go to the step 2.
2
Input width of the printing area.
• Set the printing area in the Y direction.
If you know the printing width:
(1) Press
(2) Press the
• The carriage moves.
If you do not know the printing width:
(1) Press the
(2) Press the
• The carriage moves.
3
Set the printing origin.
(1) Press
position (origin).
• Put an arrow mark of the carriage on the setting position.
(2) Press the
• If "MANUAL" is set on the Step 2, go to the Step 4.
• If a number is entered for the printing width on the Step 2, the left
end of the printing area is automatically adjusted to the entered
number, and the mode is returned to the LOCAL. Skip the step 4.
4
Set the width of the printing area.
(1) Press
printing area.
• Put an arrow mark of the carriage on the setting position.
(2) Press the
• After capping, the screen returns to LOCAL.
• If you set the wrong printing area, detect again from the Step 1 after performing the operation below.
(1) Press the
(2) Press
(3) Press the
(4) Press the
on the media selection screen, and
to input the value.
key.
• When inputting the printing width with
the media depending on the print start position set on the Step 3.
key to select "MANUAL".
key.
to move the carriage to the print start
key.
to move the carriage to the left end of the
key.
key.
to select [MEDIA RESET].
key.
key.
Setting a Media
MED I A SE T
RO L L <
PR I N T ARE A
W i d t h
=
1 8 6
, be careful that it may print out of
PR I N T ARE A
W i d t h
=
MANUA L
> L EA F
1
0
mm
2
4
5
6
2-23
Advertisement
Table of Contents
