Perform Setting To Reduce Stripes Between Passes - MIMAKI Tx500-1800B Operation Manual

Perform setting to reduce stripes between passes

In case that feeding stripes cannot be resolved even though media correction
"MAPS" (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary. (Supported from the firmware ver.1.10)
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• When printing, if you set the printing speed to 0% and more, MAPS becomes invalid. In addition, it
prints at 0% speed. When you use MAPS, set the printing speed to "minus (-)".
For 4-color
Resolution
300 x 300
300 x 300 HQ
300 x 450 HQ
600 x 600
600 x 900
600 x 1200
1
Press the
2
Press the
3
Press
4
Press the
5
Press
• Set Value : ON/OFF
6
Press the
• When you select OFF, proceed to the Step 9.
7
Press
• Set Value : -50 to +50%
• When you change the speed, nozzle recovery effect cannot work in some cases. Use it
Pass Scan speed
1 pass Normal speed
2 pass Normal speed
3 pass Normal speed
2 pass Normal speed
4 pass High speed
3 pass Normal speed
6 pass High speed
4 pass Normal speed
8 pass High speed
key in LOCAL.
key.
to select [MAPS].
key.
to set ON/OFF.
key.
to change print speed.
after checking.
( P.2-33)
For more than 6-color
Resolution Pass
300 x 300 2 pass
300 x 300 HQ 4 pass
3 pass
600 x 450
6 pass
4 pass
600 x 600
8 pass
6 pass
600 x 900
12 pass
8 pass
600 x 1200
16 pass
F UNC T I ON
S E T UP
S E T UP
F E ED COMP .
S E T UP
MA PS
MA PS
: OF F
MA PS
: ON
PR I N T S P EED AD J US T
=
PR I N T S P EED AD J US T
=
is performed, make
Scan speed
Normal speed
Normal speed
Normal speed
High speed
Normal speed
High speed
Normal speed
High speed
Normal speed
High speed
[ EN T ]
[ EN T ]
[ EN T ]
0 %
1 0 %
3-5
1
1
3
5
6