Table of Contents
Advertisement
7
After passing the media to the turn-back bar of
the upper side of the pressure roller, wind the
media around the turn-back bar roller.
• Smoothing wrinkle roller can function
• Smoothing wrinkle roller cannot
8
Check that the media is not set slanted from the
media roll ends, the centering sensor, and the
pressure roller.
• When you wish to set the media of
• If the media is set slanted, adjust the slanted part by
moving the media right and left.
• If you set the media of maximum width (1860mm), be
careful about it including confliction with the belt encoder.
Even if you move the media, misalignment cannot be
corrected in some cases. Therefore, perform adjustment
of the centering position etc. to prevent the media from
slanted setting.
9
Return the safety pins to the original
position.
2-16
when the media is set at the center
basis.
function when the media is set at the
right end basis. In this case, do not use
the smoothing wrinkle roller.
Smoothing wrinkle roller
maximum width (1860mm), set it on the
position where it does not conflict with
the belt encoder. If the media may be
caught in the belt encoder, normal
printing cannot be performed.
Turn-back bar roller
pressure roller
pressure roller
See from the rear side of the machine and
check that the media is set straight.
Advertisement
Table of Contents
