Table of Contents
Advertisement
6
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning solution for
maintenance. Wipe off so that cleaning solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned automatically.
7
Press the
8
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before the
solution overflows from the cap.
9
Close the right maintenance cover then press the
key.
10
Press
solution to be left as it is.
• Set value : 1 to 15 minutes (Unit: minute)
11
Press the
• The cleaning solution filled in the cap is absorbed.
• The screen on the right is displayed only for the duration set in the
step 10.
• It returns to the step2 after the duration.
• When nozzle missing is not cleared even after this washing is carried out several times, contact the
distributor in your region or our service office.
4-18
key.
• Until washing liquid is filled, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the Step 8 is completed and you close the front cover, press the
key. If you press the
the original position.
to set the time for the cleaning
key.
Cap rubber
cover
F i l l
COMP L E T ED ( NEX T ) [ EN T ]
key before washing liquid is filled, the carriage returns to
L E AV I NG T I ME
=
L E AV I NG T I ME
=
Cap rubber
t h e
l i q u i d .
1 m i n
2 m i n
P L E A SE WA I T
0 0 : 0 0
* * C L EAM I NG * *
P L E A SE WA I T
Advertisement
Table of Contents
