Operation Panel (Rear surface of media feeding part)
1
7
Name
[BELT] button
(1)
[FEED BACKFEED] button
(2)
[CENTERING MANUAL] lever
(3)
[PRESSURE ROLLER UP DOWN]
(4)
lever
[MEDIA END] switch
(5)
Air pressure gauge
(6)
[Emergency] button
(7)
[AUTOMATIC] lamp
(8)
[CLUTCH TUNING] dial
(9)
Air pressure adjusting dial
(10)
Power of media feeding part
Name
Power switch of the media feeding part
(1)
[Emergency] button
(2)
[POWER ON] lamp
(3)
2
3
4
8
9
When you press " I ", the belt will move, and when you press "O", it
will stop.
When the green light turns off by pressing, the moving direction of
the belt is changed in the direction of feed back.
Rotating to right or left, adjust the media position manually. In the
AUTOMATIC mode, you cannot adjust even if you operate the lever.
After adjusting the position in the MANUAL mode, change to the
AUTOMATIC mode.
The roller goes up by rotating to the "UP" side, and goes down by
rotating to the "DOWN" side.
When it lights in green by pressing this, the media end detection
becomes valid.
Displays the pressure of the pressure roller.
Immediately stops this machine under operation.
When it is in the AUTOMATIC mode, this lights in green.
Adjusting the rotating friction of the feeding media.
Adjusts the pressure of the pressure roller.
1
2
3
Turning on/off the power of the media feeding part.
Immediately stops this machine under operation.
At lighting up, representing that the power of the media feeding part
is in "ON".
Names of Parts and Functions
5
6
10
Function
Function
1
3
4
5
6
1-9