Transmission Report; F Code - Fuji Xerox DocuCentre 1085 User Manual

Sender Name 2
Uses the send header registered to Sender Name 2.
Recipient Name
Prints a recipient name which is registered in a Speed Dial, along with a sender name.
This is available only when you dial using Speed Dial, One Touch Dial, or Address
Book.

Transmission Report

With this feature enabled, the machine prints a report at the end of the transmission
that shows the transmission result.
The System Administrator specifies whether to print out a report when sending a fax to
a single destination, whether to print out a report when sending a fax to multiple
destinations, and whether to print out the scanned documents with the report. For more
information about reports, refer to Report Settings in the Setups chapter on page 161.
1.
Press the < > or < > button to display
[Trans. Report] on the Fax screen.
2.
Select [Trans. Report] using the
<Select> button.
3.
Select the required option.
4.
Press the <Enter> button.
Undelivered
Prints a report only when transmission fails.
Off
Never prints a report.
On
Always prints a report no matter how the transmission ends.

F Code

This feature enables fax transmissions using the F Code defined by the
Communications and Information network Association of Japan. The F Code standard
is based on Recommendation T.30 defined by ITU Telecommunication Standardization
Sector (ITU-T), and allows communication with remote machines that support the
same standard, regardless of their manufacturers.
You must know the F Code and the password (if one is set up) of the remote machine
before sending or retrieving a document.
Fax Features
75