Fuji Xerox DocuCentre 1085 User Manual page 145

• Add Port No. – Specify the port number 0, 80, or within the range of 8000 to 9999.
• Connection Time-Out – Specify the period of time the machine fails to receive or
send data before connection time-out is activated. Connection time-out can be set
within the range of 0 to 65535 seconds, in 1 second increments.
• TBCP Filter – Specify whether to [Enable] or [Disable] the TBCP filter when the
PostScript data is processed.
EtherTalk
Use to set up EtherTalk.
• Port Status – Specify whether to [Enable] or [Disable] the port status of EtherTalk.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the computer.
USB
Use to set up USB.
• Port Status – Specify whether to [Enable] or [Disable] the port status of USB.
• Print Mode – Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received and interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from computers is processed as each of these
respective data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the computer.
• Auto Eject Time – Specify the time to wait until automatically ejecting the remaining
data in the memory of the machine when data is not being received. Any time can
be specified within the range 5 to 1275 seconds in 5 second increments.
• Adobe Protocol – Specify the PostScript communications protocol. Select [Normal]
when the communication protocol is ASCII format. Select [Binary] when the
communication protocol is binary format. With some data, the data is processed for
printing faster than [Normal]. Select [TBCP] when the communication protocol is a
mixture of ASCII format and binary format, and these formats are switched by
specific control codes.
Port9100
Use to set up Port9100.
• Port Status – Specify whether to [Enable] or [Disable] the port status of Port9100.
• Print Mode – Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received and interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from computers is processed as each of these
respective data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the computer.
Print Settings
145