Fuji Xerox DocuCentre 1085 User Manual page 199

Code
02FFFF • E-mail address is specified as the Speed Dial number for the
• The content of the Speed Dial number set for the fax sending
02xxxx • The characters you entered (* and #) are not supported for pulse
• Check that the destination registered in the Fax Program actually
09xxxx Incompatibility errors. For example, when you retrieve a document from
a remote machine, the document to be polled is not ready on their
machine. Ask the other party to set the document for polling.
10xxxx An error occurred during F Code transmission. Check the status of the
remote machine.
11xxxx An error occurred during F Code reception. Check the status of the
remote machine.
33xxxx Check the remote machine or the telephone line. If an error cannot be
resolved, contact the Customer Support Center.
45xxxx The machine's memory is full. Delete unnecessary data and ask the
other party to send the document again.
46xxxx A document jam occurred. Remove the jammed document and reload
the documents. Refer to Paper Jams on page 184.
47xxxx The machine has run out of paper, or a left cover of the machine is open
during receiving data. Load new paper or close the left cover.
70xxxx 700002 Check the remote machine or the telephone line. If the error cannot be
resolved, contact the Customer Support Center.
700005
700008
7001xx
71xxxx 7101xx Check the remote machine or the telephone line. If the error cannot be
resolved, contact the Customer Support Center.
7103xx
72xxxx 7201xx Check the remote machine or the telephone line. If the error cannot be
resolved, contact the Customer Support Center.
7203xx
Description and Corrective Action
forwarding destination or the number has been changed to e-mail
address, in Administrator Transfer settings. Administrator Transfer
feature is compatible only with fax sending. Set a fax number for the
forwarding destination.
destination has been changed from fax number to e-mail address, or
the content of the Speed Dial number set for the e-mail destination
has been changed from e-mail address to fax number. Check the
content and specify the destination that corresponds to the type of
sending.
dialing. Check that the line type is set to PB in Local Terminal
Information, or that the fax numbers registered for speed dialing do
not contain any of these characters.
exists.
Fault Codes
199