Paper And Other Media; Loading Paper; Preparing Paper For Loading; Loading Paper Into The Paper Trays - Fuji Xerox DocuCentre 1085 User Manual

8 Paper and Other Media

The machine is designed to use a variety of paper types and other media. This chapter
provides information about loading paper and other types of media into the machine.

Loading Paper

This section provides information on how to load paper into trays.
WARNING
Do not use conductive paper such as carbonic paper or coated paper. When paper
jam occurs, it may cause short-circuit and eventually a fire accident.
NOTE: Make sure the side and rear paper guides on the trays are properly positioned
to match the size of paper loaded. If there is a gap between the paper stack and the
guides, paper may not be fed to the machine properly, or paper jams may occur.
For information about configurable paper sizes and media types for each tray, refer to
Supported Paper Sizes and Types on page 127.
For information about the acceptable range of paper sizes and capacity for each tray,
refer to Specifications in the Appendix chapter on page 209.

Preparing Paper for Loading

Before loading paper into the paper trays, fan the edges. This procedure separates any
sheets of paper that are stuck together and reduces the possibility of paper jams.
NOTE: To avoid paper jams and misfeeds, do not remove paper from its packaging
until required.

Loading Paper into the Paper Trays

Depending on the machine configuration, up to four paper trays will be available
excluding Tray 5 (bypass tray).
NOTE: If the machine is processing a job, do not open the active paper tray.
123