Fuji Xerox DocuCentre 1085 User Manual page 117

Feature name
Protocol Settings SNMP
When accessing the printer via SNMP, configure the
following options on this page:
Community Name (Read Only) – Enter the community name
used for reference and display.
Community Name (Read/Write) – Enter the read/write
community name.
Community Name (Trap Notification) – Enter the trap
notification community name.
System Administrator – Enter the name of the System
Administrator.
IPP
This page allows you to configure the following options when
using IPP (Internet Printing Protocol).
Port Number – The default IPP port number 631 will be
displayed. This is a display-only item.
Add Port No. – Enter the port number.
TBCP Filter – This is only displayed when PostScript is
enabled.
Administrator Mode – Allows you to enable/disable to
operate by the System Administrator.
DNS – Allows you to configure whether to enable/disable
DNS.
Connection Time-Out – Specifies the time-out period when
transmission fails.
Port9100
This page allows you to configure the time-out settings for
the Port9100.
Port Number – Enter a value for the port number between
8000 and 9999.
TBCP Filter – This is only displayed when PostScript is
enabled.
Connection Time-Out – Specifies time-out period when
transmission fails.
UPnP
This page allows you to configure the UPnP protocol.
Port Number – Enter the port number 80, or between 8000
and 9999 that receives requests from the browser.
SSDP:
Allows you to configure the SSDP protocol used for UPnP.
• Valid Advertising Period – Specify the displayed time of
the machine on the network between 60 and 4320
minutes in 1 minute increments.
• Maximum TTL - Enter the maximum TTL between
1 and 10.
E-mail
POP3 Server Address – Up to 256 characters can be
entered, including . (full stop) and - (hyphen).
Setting items
Properties
117