Print Settings; Network/Port - Fuji Xerox DocuCentre 1085 User Manual

9 Setups

Print Settings

This section describes how to specify settings for the printer feature. For more
information, refer to the following.
Network/Port – page 142
System Settings – page 147
Printer Settings – page 149
Allocate Memory – page 150
Initialize/Delete Data – page 151
Report/List – page 152
Software Option – page 152
1.
Select [Print Settings] on the [System
Settings] screen using the <Select >
button.
2.
Press the <Enter> button.
3.
Select the required option by selecting
[ ] or [ ] using the <Select> button on
the [Menu] screen.
4.
Press the <Enter> button.

Network/Port

Use this feature to specify the type of interface for the machine connected to a
computer, or the conditions of communications.
NOTE: If an error occurs while printing a document or sending a direct fax via a
Parallel, USB or Port9100 port, a large amount of unnecessary data may be printed
out. When this happen change the port to [LPD] or [SMB].
1.
Select the required option by selecting
[ ] or [ ] using the <Select> button.
2.
Press the <Enter> button.
3.
Perform the necessary operations.
4.
Press the <Enter> button. The selected option is indicated by an asterisk (*).
Parallel
Use to set up parallel interface.
• Port Status – Specify whether to [Enable] or [Disable] the port status of parallel
interface.
142