Fuji Xerox DocuCentre 1085 User Manual page 143

• Print Mode – Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received and interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from computers is processed as each of these
respective data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the computer.
• Adobe Protocol – Specify the PostScript communications protocol. Select [Normal]
when the communication protocol is ASCII format. Select [Binary] when the
communication protocol is binary format. With some data, the data is processed for
printing faster than [Normal]. Select [TBCP] when the communication protocol is a
mixture of ASCII format and binary format, and these formats are switched by
specific control codes.
• Auto Eject Time – Specify the time to wait until automatically ejecting the remaining
data in the memory of the machine when data is not being received. Any time can
be specified within the range 5 to 1275 seconds, in 5 second increments.
• Bi-directional – Specify whether to [Enable] or [Disable] bi-directional
communications (IEEE 1284) on the parallel interface.
LPD
Use to set up LPD.
• Port Status – Specify whether to [Enable] or [Disable] the port status of LPD.
• Print Mode – Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received and interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from computers is processed as each of these
respective data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the computer.
• Connection Time-Out – Specify the period of time the machine fails to receive or
send data before connection time-out is activated. Connection time-out can be set
within the range of 2 to 3600 seconds, in 1 second increments.
• TBCP Filter – Specify whether to [Enable] or [Disable] the TBCP filter when the
PostScript data is processed.
• Port No. – Specify the port number 515 or a value between 8000 and 9999.
NetWare
Use to set up NetWare.
• Port Status – Specify whether to [Enable] or [Disable] the port status of NetWare.
• Transport Protocol – Specify the transport protocol to be used for NetWare. Select
[TCP/IP], [IPX/SPX], or both.
Print Settings
143