Fuji Xerox DocuCentre 1085 User Manual page 195

Symptom
The machine displays a tray fault.
Deformed transparencies
Blank output
Streaks, solid or dotted lines, or spots
Paper delivered to an output tray is not
properly stacked up.
Troubleshooting Tables
Recommendation
• Follow the steps below
1. Open the paper tray.
2. Move the paper tray guides away from the
paper.
3. Move the paper tray guides against the
paper so that they are just touching the
paper.
4. Close the paper tray.
5. Power the machine off and then on.
• Check that [Transparency] is selected on
the screen. The machine automatically
adjusts for different types of media. Paper
can tolerate more heat than
transparencies.
• Transparencies can be loaded only Tray
2–4 (optional) or Tray 5 (bypass tray).
• Check that the document is loaded face up
in the document feeder.
• Check that the document is loaded face
down on the document glass.
• If the toner cartridge is new, the toner may
not be dispensed. Repeat the job.
• Check that the seal tape has been
removed from the new drum cartridge.
• Reinstall the drum cartridge and the toner
cartridge.
• Replace the drum cartridge.
• Replace the toner cartridge if the screen
message for replacement is displayed.
• Clean the document glass, CVT glass (the
narrow strip of glass located at the left
hand side of the document glass), areas
under the platen cover, the document
feeder, and the paper guides.
• If the machine has been idle for an
extended period of time, or if the toner or
drum cartridge is new, begin the job again.
• Run the job using the document glass.
• Reinstall the drum cartridge.
• Check the quality of the document.
• Load fresh paper.
• Check the humidity of the machine
location.
• Flip over the paper stack in the paper tray,
or rotate it head to toe.
195