Fault Codes - Fuji Xerox DocuCentre 1085 User Manual

11 Problem Solving
Cannot store a document when using
[Doc.for Polling] due to full memory.
The fax communication finishes with an error
message.
The machine will not answer incoming calls.
The machine answers calls, but will not
accept incoming data.
An image is reduced on a fax transmission.
Received fax and report documents will not
print.

Fault Codes

When a fault occurs, the screen displays a message on how to clear the fault.
Some faults indicate customer maintenance, while others require the attention of the
System Administrator. The following table represents some of the fault codes and their
corresponding corrective actions. These may display in the [Error Information]
available in the Machine Status mode.
00xxxx
01xxxx
198
Symptom
Code
Reload and send the document again or the remote machine sent a
polling request when it should have sent a document. Ask the other
party to set the document on their machine and send it to your machine.
The document you set in the document feeder is too short, or the
document has been pulled out of the feeder. Check and reload the
document.
• Cancel the operation and try again after
additional memory is available with
deleting, printing the stored job.
• Press the <Machine Status> button and
select the [Error Information], check the
error status.
• Refer to Fault Codes on page 198.
• Select [Auto Receive] on the [Fax
Receiving Mode] screen.
• If the job contains several diagrams, the
machine may not have enough memory.
• Clear memory by printing then deleting the
stored data.
• Check the original size of the documents.
Documents may be reduced based on the
paper specification at the receiving
machine.
• Check the Received Settings in facsimile
features. The received data is set to print a
paper loaded in the non-use tray.
Description and Corrective Action
Recommendation