Fuji Xerox DocuCentre 1085 User Manual page 124

8 Paper and Other Media
1.
Pull out the paper tray towards you.
NOTE: To avoid jams and misfeeds, do not
load paper on top of any remaining paper in
the tray. Remove the paper, and reload it on
top of the new stock loaded.
2.
When loading paper into Tray 1, push
the metal plate down until it clicks.
When loading paper into Tray 2, 3, and 4,
go to step 3.
3.
If required, move the paper tray guides
further out to load the new stock.
To adjust the side and rear guides, pinch
the guide lever on each guide and slide
the guides to their new position.
To secure the guides in position, release
the levers.
NOTE: Tray 1 can only be loaded with plain
paper. Tray 2, 3, and 4 can be loaded with a
variety of different media stock. When
changing the type of stock in the tray, refer
to Paper Type in the Setups chapter on
page 141. For more information about
reprogramming the paper type, contact the
System Administrator.
4.
Load the paper neatly and tightly
against the left-hand side of the tray
with the print side facing upward. Tray 1
can hold up to a 27 mm stack of paper.
Tray 2, 3, or 4 can hold up to a 54 mm
stack of paper.
NOTE: Do not load paper above the
maximum fill line.
124