Report Settings - Fuji Xerox DocuCentre 1085 User Manual

Report Settings

Use this feature to specify how reports are to be automatically printed.
NOTE: Even if you set the machine to print out reports automatically, they cannot be
printed out when the memory is insufficient.
Transmission Report
Configure the settings for printing report that shows the result of transmission.
• Single Destination – Configure the settings to be used when sending fax to a single
destination. If you select [Undelivered], the machine prints a report only when
transmission fails.
• Multiple Destination – Configure the setting to be used when sending fax to multiple
destinations. If you select [Undelivered], the machine prints a report only when
transmission fails. With [As Single Dest'n] selected, the machine follows the setting
made for [Single Destination].
• Original Image – Specify whether to print out scanned documents with a report.
NOTE: Even if [Original Image] is set to [On], the document may be printed without
images for reasons such as insufficient memory, direct transmission and manual
transmission.
NOTE: When [Original Image] is set to [On] and the report is printed on A4 paper, the
orientation of the printed report may not match that of the paper. This occurs because
the set orientation of the paper used for the report does not match the print orientation.
The paper used for printing reports should be A4, set to landscape orientation.
Activity Report
Specify whether or not to automatically print the report of the transmission result every
50 transactions.
The number of documents sent exceeds 50 and the number of documents received
exceeds 50, the machine automatically prints the Sent Report and the Received Report
respectively.
NOTE: When the report output is disabled for reasons such as paper out, the machine
stores and retains the information until the output is enabled. However, only up to 96
of the latest transaction information can be stored.
Fax Settings
161