Fuji Xerox DocuCentre 1085 User Manual page 114

7 CentreWare Internet Services
Protocol Settings
114
Feature name
EtherTalk
This is only displayed when PostScript is enabled.
Printer Name – Enter the printer name for EtherTalk.
Zone Name – Enter the EtherTalk zone name.
Printer Type – This is a display-only item.
SMB
This page allows you to configure the SMB protocol settings
for the following options.
Workgroup – Enter the workgroup name. Up to 15
characters can be entered.
Host Name – Enter the host name. Up to 32 characters can
be entered.
Administrator Name – Enter the System Administrator name.
Administrator Password – Enter the System Administrator
password.
Re-enter Password – Allows you to verify the System
Administrator password by re-entering the same password
specified in Administrator Password.
Maximum Sessions – Allows you to specify the maximum
number of sessions.
TBCP Filter – This is only displayed when PostScript is
enabled.
Unicode Support – Allows you to configure whether to notify
the host name and workgroup name in Unicode characters
during SMB transmission.
Auto Master Mode – Allows you to enable/disable (on/off)
Auto Master Mode. Enable Auto Master Mode to allow the
machine to become the domain master browser at startup if
there is no master browser in the workgroup. This allows
computers in the workgroup to access the machine
automatically. When Auto Master Mode is disabled, the
workgroup must have a designated domain master browser
for the entire domain.
Encrypt Password – Allows you to enable/disable Encrypt
Password during SMB transmission.
NetWare
This page allows you to configure the following settings for
NDS, transport protocol and SLP.
Host Name – Enter the host name.
Active Mode – Selects the Active Mode for the printer when
using NetWare.
• Directory: PServer Mode: Select this when using the
printer server mode in directory service.
• Bindery: PServer Mode: Select this when using the printer
server mode in bindery service.
File Server Name – Enter the file server name.
Polling Interval – Set the time interval from when print data
enter the print queue until printing starts.
Setting items