Select The Features - Fuji Xerox DocuCentre 1085 User Manual

4 Fax
1.
Load documents face up into the
document feeder or face down on the
document glass.
For more information on how to load the
documents, refer to 1. Load the Documents
in the Copy chapter on page 49.
Scan the Documents
There are two methods of scanning the documents. To select which way to scan, refer
to Scan Size on page 73.
• Auto Detect
Standard size documents can be automatically detected. If the document is not a
standard size, or the size cannot be detected, the machine will automatically choose
the size to prevent image loss. For more information about sizes to be detected or
replaced automatically, refer to When Using the Fax Feature in the Appendix chapter
on page 216.
• Select the Scan Size
You can select the scan size from the preset sizes. For more information on how to
select the scan size, refer to Scan Size on page 73.
NOTE: The long page scan feature is only available when using the document feeder.
This feature allows you to scan up to 1,000 mm in length in simplex mode, 432 mm in
duplex mode. For receiving, the System Administrator can select either to cut off or
reduce the image. The ranges are 0–24 mm for cutting off and, 60–100% for reducing.
If the document length cannot be reduced or cut off, the image is automatically
divided. For more information, refer to Long Size Originals in the Setups chapter on
page 156.

2. Select the Features

Only those features relevant to the machine configuration will be available.
NOTE: If the machine remains idle for a set time (determined by the System
Administrator), the settings will be reset. For more information, refer to Auto Clear in
the Setups chapter on page 134.
1.
Press the <Fax> button on the control
panel. Ensure that the Fax screen is
displayed.
64
<Fax> button