Configuring The Global Radius Transmission Retry Count And Timeout Interval; Configuring The Radius Transmission Retry Count And Timeout Interval For A Server - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 17 Configuring RADIUS
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Command
Step 4
switch# show radius-server
directed-request
Step 5
switch# copy running-config
startup-config

Configuring the Global RADIUS Transmission Retry Count and Timeout Interval

You can configure a global retransmission retry count and timeout interval for all RADIUS servers. By
default, a switch retries transmission to a RADIUS server only once before reverting to local
authentication. You can increase this number up to a maximum of five retries per server. The timeout
interval determines how long the Nexus 5000 Series switch waits for responses from RADIUS servers
before declaring a timeout failure.
To configure the global RADIUS transmission retry count and timeout interval, perform this task:
:
Command
Step 1
switch# configure terminal
Step 2
switch(config)# radius-server retransmit
count
Step 3
switch(config)# radius-server timeout
seconds
Step 4
switch(config)# exit
Step 5
switch# show radius-server
Step 6
switch# copy running-config startup-config
Configuring the RADIUS Transmission Retry Count and Timeout Interval for a
Server
By default, a Nexus 5000 Series switch retries transmission to a RADIUS server only once before
reverting to local authentication. You can increase this number up to a maximum of five retries per
server. You can also set a timeout interval that the Nexus 5000 Series switch waits for responses from
RADIUS servers before declaring a timeout failure.
To configure RADIUS transmission retry count and timeout interval for a server, perform this task:
OL-16597-01
Purpose
(Optional) Displays the directed request configuration.
(Optional) Copies the running configuration to the
startup configuration.
Purpose
Enters configuration mode.
Specifies the retransmission count for all RADIUS
servers. The default retransmission count is 1 and
the range is from 0 to 5.
Specifies the transmission timeout interval for
RADIUS servers. The default timeout interval is 5
seconds and the range is from 1 to 60 seconds.
Exits configuration mode.
(Optional) Displays the RADIUS server
configuration.
(Optional) Copies the running configuration to the
startup configuration.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring RADIUS Servers
17-9