5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
CAUTION
Before accessing the service menu, do the following:
Confirm that there is no print data in the printer buffer (the Data In LED
must not be lit or blinking).
If there is some data in the buffer, wait until all data has been printed.
5.1.1 SERVICE MODE OPERATION
The Service Program Mode is for use by technical professionals only, so
NOTE:
that they can properly maintain product quality. If this mode is used by
anyone other than the technical professional for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed.
Entering the Service Mode
There are two ways to enter the service mode.
Method 1: Turn the machine on while pressing the "On Line" key and "Escape" key
together until "SYSTEMver x.xx/ 1. Service" shows on the display.
If you switch the machine off, any jobs stored on the hard disk using the
NOTE:
sample print and protected print features will be deleted.
Check first with the user tools to see if there are any jobs stored with these
features (Menu key - Sample Print, or Protected Print). If so, you may use
method 2 to enter service mode.
Method 2: Press the "Up/Down arrow" keys together for about 5 seconds, then
press the "Enter" key.
The "SYSTEMver x.xx/ 1. Service" appears on the display.
The machine automatically goes off line when you enter the service mode.
NOTE:
SM
CÓPIA NÃO CONTROLADA
From Feed
Online
Escape
Menu
Job Reset
Data In
Power
Alert
5-1
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Enter
G105S902.WMF
G104