Ricoh G104 Service Manual page 175

5505 [Error Alarm]
5505 001
5507 [Supply Alarm]
5507 001 Paper Supply Ala
5507 003 Toner Supply Ala
5507 128 Interval: Others
5507 133 Interval: A4
5507 134 Interval: A5
5507 142 Interval: B5
5507 164 Interval: LG
5507 166 Interval: LT
5507 172 Interval: HLT
5801 [Memory Clear]
5801 001 All
5801 002 Engine
5801 003 SCS
5801 004 IMH
5801 005 MCS
5801 008 PRT
5801 010 Web Service
5801 011 NCS
5801 014 DCS Setting
SM
CÓPIA NÃO CONTROLADA
*CTL Sets the error alarm level. If an SC code
occurs, the error alarm counter increases by
+1. If no SC code occurs while the set
number of paper is output, the jam alarm
counter decreases by -1. The error alarm
occurs when the error alarm counter reaches
+5.
[0 to 255 / 30 / 1/step]
0: Disables the PM alarm
The alert is sent to the e-mail address that is
specified for the system administrator using
a browser and the built-in web server (Web
Image Monitor).
When SP5-866-001 is set to 1, this SP is
enabled.
*CTL Enables or disables the supply alarm.
[0 to 1 / 0 / -] Alphanumeric
-
0: Off, 1: On
*CTL Sets the paper supply alarm level. A paper
supply alarm counter increases by +1 when
*CTL
a sheet of the related size is used. The paper
*CTL
supply alarm occurs when one of the paper
*CTL
supply alarm counters gets to the set value.
*CTL
[250 to 10000 / 1000 / 1/step]
*CTL
The alert is sent to the e-mail address that is
*CTL
specified for the system administrator using
a browser and the built-in web server (Web
Image Monitor).
When SP5-866-001 is set to 1, this SP is
enabled.
- Resets the SP5801-002 through 016 except
the security related data in 003, 010, 011and
015. These cannot be reset with SP mode.
- Resets or deletes the engine-related data.
- Clears the system settings.
- Clears IMH data. DFU
- Clears MCS data. DFU
- Clears the printer application settings.
*CTL
Clears the web service data and the network
application data.
*CTL Initializes the system default and interface
settings (IP address also), SmartNetMonitor
for Admin, WebStatusMonitor settings, and
the TELNET settings.
*CTL Resets or deletes the DCS-related data.
5-59
CÓPIA NÃO CONTROLADA
ENGINE SERVICE MODE
G104