Ricoh G104 Service Manual page 500

Service Mode Table
5857 002 Target
5857 005 Save to HDD
5857 006 Save to SD Card
5857 009 HDD to SD Latest
5857 010 HDD to SD Any
5857 011 Erase HDD Debug
5857 012 Erase SD Debug
5857 013 Dsply-SD Space
5857 014 SD to SD Latest
5857 015 SD to SD Any
5857 016 Make HDD Debug File *CTL
5857 017 Make SD Debug File
5858 [Debug Log Save: SC]
5858 001 Engine SC
G160/G161
CÓPIA NÃO CONTROLADA
Function.
[0 or 1 / 0 / 1/Step] Alphanumeric
0: OFF, 1: ON
Sets the storage location for the debug log.
*CTL [2 or 3 / 2 / 1/step]
2: HDD, 3: SD
*CTL Sets the key number of the debug log.
*CTL Sets the key number of the debug log.
Copies the most recent 4 MB of the debug log
*CTL
from the hard disk to the SD card.
Sets the key number of the debug log copied
*CTL
from the hard disk to the SD card.
*CTL Deletes the debug log from the hard disk.
*CTL Deletes the debug log from the SD card.
*CTL Shows the free space on the SD card.
Copies the most recent 4 MB of the debug log
*CTL
from an SD card to a different SD card.
Sets the key number of the debug log copied
*CTL
from an SD card to a different SD card.
Makes a log file on the HDD to save debug
logs. To save debug logs, the controller
makes a log file first, then writes data in the
file. This procedure can use much time. The
user can switch off the main power switch
before the log is written in the file. To prevent
*CTL
this possible problem, you can prepare a log
file in advance. If you do this, the controller
uses less time to save logs because the log
file is prepared.
Collects debug logs when an engine-related
SC code occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
5-120
CÓPIA NÃO CONTROLADA
SM