Downloading Nvram Data - Ricoh G104 Service Manual

Downloading NVRAM Data

Copy the data from the SD card to the NVRAM (referred to as "to download
NVRAM data" in this section) after you replace the NVRAM. If you cannot
download NVRAM data, manually input the necessary settings.
1. Make sure that the main power switch is off. If it is on, turn it off.
2. Make sure that you have the correct SD card that contains the necessary
NVRAM data.
3. Insert the SD card into slot 3.
4. Turn on the main power switch.
5. Enter SP mode.
6. Select SP5825-001 (NVRAM Download).
7. Push the enter key. The download starts.
The machine cannot execute the download if the file name in the SD
NOTE:
card is different from the serial number of the printer ( Uploading
NVRAM Data).
8. Exit the SP mode.
9. Turn off the main power switch.
10. Remove the SD card.
11. Turn on the main power switch.
12. Check that the NVRAM data is correctly downloaded.
This procedure does not download the following data to the NVRAM:
• Total Count
• Serial Number
SM
CÓPIA NÃO CONTROLADA
5-105
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE
G104