Others - Ricoh G104 Service Manual

SERVICE PROGRAM MODE
Environment
LL: Low temperature and Low humidity
ML: Medium temperature and Low humidity
MM: Medium temperature and Medium humidity
MH: Medium temperature and High humidity
HH: High temperature and High humidity

Others

The following symbols are used in the SP mode tables.
FA: Factory setting
(Data may be adjusted from the default setting at the factory. Refer to the factory
setting sheets enclosed, which is located underneath the jammed paper removal
decal.)
DFU: Design/Factory Use only
Do not touch the SP mode in the field.
"P" in the right hand side of the mode number column means that this SP mode
relates to the Printer Controller. If "P" is not in the column, this SP mode relates to
the Printer Engine.
A sharp (#) to the right hand side of the mode number column means that the main
switch must be turned off and on to effect the setting change.
An asterisk (*) to the right hand side of the mode number column means that this
mode is stored in the NVRAM (Engine and Printer Controller). If you do a RAM
clear, this SP mode will be reset to the default value. "EGB", "CTL" and "NV"
indicate which NVRAM contains the data.
• EGB: NVRAM on the EGB board
• CTL: NVRAM on the controller board
• NV:
NVRAM on the NVRAM expansion board (user account enhancement
kit)
The settings of each SP mode are explained in the right-hand column of the SP
table in the following manner.
[ Adjustable range / Default setting / Step ] Alphanumeric
If "Alphanumeric" is written to the right of the bracket as shown above, the
NOTE:
setting of the SP mode is displayed on the screen using alphanumeric
characters instead of only numbers. However, the settings in the bracket in
the SP mode table are explained by using only the numbers.
G104
CÓPIA NÃO CONTROLADA
5-4
CÓPIA NÃO CONTROLADA
SM