Ricoh G104 Service Manual page 476

Service Mode Table
3612 010 DEV.SetUp [M]
3612 011 DEV.SetUp [C]
3612 012 DEV.SetUp [Y]
[Low Resolution] (Threshold, [Color])
SP 3701-001 controls if the pixel count is used in hybrid toner supply mode or
not. If this SP is 'on', it is used if the image coverage ratio for the page is below
3701
a threshold value (if the coverage is above this ratio, then the TD sensor is
used). If this SP is 'off', then the TD sensor is always used.
SP3701-002 to 005 control the threshold values for the image coverage ratio.
3701 001 Low Resolution
3701 002 Threshold: [K]
3701 003 Threshold: [M]
3701 004 Threshold: [C]
3701 005 Threshold: [Y]
3721 [Low Resolution] Toner Refresh Mode Setting in Low Image Coverage Ratio
3721 001 Toner Refresh Mode
3721 002 S: Toner Refresh
3721 003 Toner refresh coef.
3721 004 Interval Bk
3721 005 Interval Col
3731 [SUM.ImageArea]
3731 001 [Bk]
3731 002 [M]
3731 003 [C]
G160/G161
CÓPIA NÃO CONTROLADA
*EGB
*EGB
*EGB
[0 to 1 / 0 / -]
*EGB
0: Off, 1: On
*EGB
*EGB
[0 to 100 / 1 / 1%/step]
*EGB
*EGB
Enables or disables the toner refresh mode.
*EGB [0 or 1 / 0 / -]
0: On. 1: Off
Toner refresh mode is done if the percentage
of pages that have low image coverage is
*EGB
larger than this threshold value.
[0 to 50 / 20 / 1%/step]
Toner refreshing coefficient: DFU
*EGB
[0 to 100 / 100 / 1%/step]
*EGB Specifies the interval of the process control at
low coverage printing.
*EGB
[0 to 65535 / 0 / 1 sheet/step]
*EGB Displays the total coverage for each color
after the process control execution. This SP is
*EGB
cleared when the process control is done.
*EGB
5-96
CÓPIA NÃO CONTROLADA
SM