Ricoh G104 Service Manual page 410

Service Mode Table
2105 011 [C] 0: LS
2105 012 [Y] 0: LS
2106 Polygon Motor Stop Time
2106 001
2109 [LD BeamPattern] LD Beam Pattern
2109 001 Picture Addition
2109 002 Pattern Select
2109 004 Color Select
2111 [Manual Execut.] Manual Line Position Adjustment Execution
2111 001 Position Adjust.
2111 200 Pro. Position Adj.
2111 003 Skew Adjust.
2111 004 ID S. Adjust.
2111 005 Area.Magni.Clr.
2120 [LD Off Check]
[ID S. Display] ID Sensor Display
2143
The ID sensor assembly has three sensors: Left, Center, Right
2143 001 PWM: Left
2143 002 PWM: Center
2143 003 PWM: Right
2143 004 Avg: Left
G160/G161
CÓPIA NÃO CONTROLADA
*EGB
*EGB
Adjusts the time to stop the polygon motor
*EGB after job end.
[0 to 180 / 10 / 1 sec/step]
Adds the picture to the LD test pattern.
[0 or 1 / 0 /-]
0: Not execute, 1: Execute
Selects the LD test pattern.
[0 to 24 / 0 / 1/step]
Selects the color for the LD test pattern.
[0 to 4 / 0 / 1/step]
Performs the line position adjustment.
Performs an approximate line position
adjustment.
Performs the skew adjustment.
Tests the ID sensor.
Clears the area magnification setting.
Displays the LD off check state.
*EGB
Displays the PWM value for each sensor.
*EGB
[0 to 512 / 0 / 1/step]
*EGB
*EGB Displays the average output from each
5-30
CÓPIA NÃO CONTROLADA
SM