Ricoh G104 Service Manual page 138

SERVICE MODE TABLE
[LD Power Cont.] LD Power Control
2105
([Color], Process Speed) Process Speed -> LS: Low speed, RS: Regular speed
2105 001 [K] 0
2105 002 [M] 0
2105 003 [C] 0
2105 004 [Y] 0
2105 009 [K] 0: LS
2105 010 [M] 0: LS
2105 011 [C] 0: LS
2105 012 [Y] 0: LS
2109 [LD BeamPattern] LD Beam Pattern
2109 001 Picture Addition
2109 002 Pattern Select
2109 004 Color Select
2111 [Manual Execut.] Manual Execution
2111 001 Position Adjust.
2111 002 Pro. Position Adj.
2111 003 Skew Adjust.
2111 004 ID S. Adjust.
2120 [LD Off Check]
[ID S. Display] ID Sensor Display
2143
The ID sensor assembly has three sensors: Left, Center, Right
2143 001 PWM: Left
2143 002 PWM: Center
2143 003 PWM: Right
2143 004 Avg: Left
2143 005 Avg: Center
2143 006 Avg: Right
2143 007 Max: Left
2143 008 Max: Center
2143 009 Max: Right
2143 010 Min: Left
2143 011 Min: Center
2143 012 Min: Right
2143 013 Max2: Left
2143 014 Max2: Center
G104
CÓPIA NÃO CONTROLADA
*EGB Adjusts the LD power.
[10 to 200 / 100 / 1%/step] DFU
*EGB
*EGB
*EGB
*EGB Adjusts the LD power at low speed.
[10 to 200 / 100 / 1%/step] DFU
*EGB
*EGB
*EGB
Adds the picture to the LD beam pattern.
[0 or 1 / 0 /-]
0: Not execute, 1: Execute
Selects the LD beam pattern.
[0 to 24 / 0 / 1/step]
Selects the color for the LD beam pattern.
[0 to 4 / 0 / 1/step]
Performs the line position adjustment.
Performs an approximate line position
adjustment.
Performs the skew adjustment.
Tests the ID sensor.
Displays the LD off check state.
*EGB Displays the PWM value for each sensor.
[0 to 512 / 0 / 1/step]
*EGB
*EGB
*EGB Displays the average output from each
sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB Displays the maximum output from each
sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB Displays the minimum output from each
sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB Displays the maximum 2 output from each
sensor.
*EGB
5-22
CÓPIA NÃO CONTROLADA
SM