Installing The New Nvram - Ricoh G104 Service Manual

Electrical Components
3. Controller board [C] (
Remove the NVRAM from the old board. Then install it on the new board.
Keep NVRAMs away from objects that can cause static electricity. The data in
NVRAMs can be corrupted by static electricity.
Make sure the NVRAM is correctly installed on the board. A half-disk is
engraved on one side of the NVRAM, and a guide mark is on one side of the
NVRAM slot. When you install the NVRAM, the half-disk and the guide mark
must be on the same side.

3.4.2 INSTALLING THE NEW NVRAM

When the NVRAM on the controller board is detective, you must replace the detective
NVRAM with a new NVRAM.
1. Controller board (see Controller Board)
2. Remove the defective NVRAM.
3. Install the new NVRAM on the controller board.
4. Reassemble the machine.
5. Plug in and turn on the main power
6. Set the date and time with the timer setting in the UP (Maintenance < Menu ) after
installing a new controller board.
If the date and time setting is not done, the WebImage Monitor will not be
available.
G160/G161
CÓPIA NÃO CONTROLADA
x 7)
3-10
CÓPIA NÃO CONTROLADA
SM