Ricoh G104 Service Manual page 566

Laser Exposure
The adjustment of the sub-scan line position for YCM uses the line position for K (color
registration). The machine measures the gaps between the lines of each color in the
pattern on the transfer belt. If the gaps for a color are not correct, the machine moves the
image of the color up or down the sub scan axis. To do this, it changes the laser write
timing for that color.
Main scan line position for KYCM
If the machine detects that the image is out of position in the main scan direction, it
changes the laser-write-start timing for each scan line.
Magnification adjustment for KYCM
If the machine detects that magnification adjustment is necessary, it changes the LD clock
frequency for the necessary color.
Skew for YCM
The adjustment of the skew for YCM uses the line position for K.
Adjustment Conditions
If SP 2153 1 is set to "1 (ON)", then automatic line position adjustment is done at the times
shown below.
After process control is done
If SP 2153 2 is set to "1 (ON)", then the adjustment is done when the following types of
process control are successfully done.
Initial process control
Interval process control
No-use time process control
Initialization
If SP2153 3 is set to "1 (ON)", then the adjustment is done when the main power is turned
on or the machine comes back from the standby mode, but only if one of the following
conditions occurs.
At a set time after the previous adjustment. The default value is 360 minutes. You can
adjust the time with SP 2153 13.
When the temperature changes after a previous adjustment by more than a set value.
The default value is "5°C ". You can adjust the temperature change value with SP 2153
12.
Printing
If SP 2153 4 is set to "1 (ON)", then the adjustment is done when the machine gets print job
data, but only if one of the following conditions occurs.
At a set time after the previous adjustment. The default value is 360 minutes. You can
adjust the time with SP 2153 13.
G160/G161
CÓPIA NÃO CONTROLADA
6-16
CÓPIA NÃO CONTROLADA
SM