Ricoh G104 Service Manual page 398

Service Mode Table
1004 076 PFU: RS: Thin
1004 077 Duplex: LS: Thin
1004 078 Duplex: RS: Thin
DEV / OPC [K]: LS:
1004 079
OHP
1004 080 DEV [CMY]: LS: OHP
1004 081 OPC [CMY]: LS: OHP
1004 082 Fusing: LS: OHP
1004 083 T.Belt: LS: OHP
1004 084 PFU: LS: OHP
1004 085 Duplex: LS: OHP
1006 [Phase Adjust.] Phase Adjustment
1006 001 Angle
1104 [Fusing Cont.] Fusing Control
Control Method
1104 001
Selects the fusing control method.
0: ON/OFF Control, 1: PID Control (Phase control)
Max. Wait Time
Adjusts the maximum waiting time for the target printing temperature of fusing
1104 022
unit. After this interval, printing will start if the temperature did not get to the
target.
G160/G161
CÓPIA NÃO CONTROLADA
optional paper tray unit.
*EGB
[-4.00 to 4.00 / -0.36 / 0.01%/step]
*EGB Adjusts the duplex motor speed.
[-4.00 to 4.00 / -0.36 / 0.01%/step]
*EGB
Adjusts the black development and OPC
*EGB motor speed.
[-4.00 to 4.00 / -1.35 / 0.01 %/step]
Adjusts the color development motor speed.
*EGB
[-4.00 to 4.00 / 0.0 / 0.01%/step]
Adjusts the color OPC motor speed.
*EGB
[-4.00 to 4.00 / -1.35 / 0.01%/step]
Adjusts the paper exit and fusing motor
*EGB speed.
[-4.00 to 4.00 / 0.6 / 0.01%/step]
Adjusts the transfer belt motor speed.
*EGB
[-4.00 to 4.00 / 0.0 / 0.01%/step]
Adjusts the speed of the feed motor in the
*EGB optional paper tray unit.
[-4.00 to 4.00 / -1.14 / 0.01%/step]
Adjusts the duplex motor speed.
*EGB
[-4.00 to 4.00 / -0.36 / 0.01%/step]
Adjusts the phase angle between the K drum
*EGB and the CMY drums.
[-180 to 180 / 0 / 1/step] DFU
*EGB [0 or 1 / 1 / -]
*EGB
[0 to 255 / 30 / 1 sec/step]
5-18
CÓPIA NÃO CONTROLADA
SM