Reinstalling Components In The Srx5400 Services Gateway Chassis After Installing It Without A Lift; Reinstalling Power Supplies After Installing The Srx5400 Services Gateway; Without A Lift; Reinstalling The Fan Tray After Installing The Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Reinstalling Components in the SRX5400 Services Gateway Chassis After Installing
It Without a Lift
Reinstalling Power Supplies After Installing the SRX5400 Services Gateway Without a Lift
154
Removing Components from the SRX5400 Chassis Before Installing It Without a Lift
on page 148
Reinstalling Components in the SRX5400 Services Gateway Chassis After Installing
It Without a Lift on page 154
After the services gateway is installed in the rack, reinstall the removed components
before booting and configuring the services gateway. You reinstall components first in
the rear of the chassis, and then in the front:
1. Reinstalling Power Supplies After Installing the SRX5400 Services Gateway Without
a Lift on page 154
2. Reinstalling the Fan Tray After Installing the SRX5400 Services Gateway Without a
Lift on page 155
Reinstalling Cards After Installing the SRX5400 Services Gateway Without a
3.
Lift on page 156
Reinstall the rightmost power supply first and then work your way to the left. To reinstall
the AC or DC power supplies, follow this procedure for each power supply (see
Figure 69 on page 155, which shows the installation of the DC power supplies):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
On an AC-powered services gateway, switch the AC input switch on each power supply
2.
to the off ( ) position. On a DC-powered services gateway, move the DC circuit breaker
O
on each DC power supply to the off (
We recommend this even though the power supplies are not connected to power
sources.
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Tighten the captive screws.
4.
) position.
O
Copyright © 2017, Juniper Networks, Inc.