Replacing The Srx5400 Services Gateway Craft Interface - Juniper SRX5400 Hardware Manual

Related
Documentation

Replacing the SRX5400 Services Gateway Craft Interface

Copyright © 2014, Juniper Networks, Inc.
Table 21: Tools and Parts Required (continued)
Tool or part
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD) grounding
wrist strap
Flat-blade (–) screwdriver
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap
Wire cutters
SRX5400 Services Gateway FRUs on page 103
To replace the craft interface, perform the following procedures in sequence:
Disconnecting the Alarm Relay Wires from the SRX5400 Services Gateway Craft
1.
Interface on page 106
Removing the SRX5400 Services Gateway Craft Interface on page 106
2.
Chapter 13: Replacing SRX5400 Services Gateway Hardware Components
Components
Craft Interface
SCB
MPC
MIC
SPC
Power supply
Routing Engine
transceivers
All
Cables and connectors
Air filter
Routing Engine
Craft interface
SCB
Cables and connectors
Fan tray
MPC
SPC
Transceivers
Cables and connectors
DC power supply
105