D-Link xStack DGS-3120 Series Cli Reference Manual page 25

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
<portlist> - Enter a list of ports used here.
all - Specify that all the ports will be used for this configuration.
medium_type - (Optional) Specify the medium type while the configure ports are combo ports
fiber - Specify that the medium type will be set to fiber.
copper - Specify that the medium type will be set to copper.
speed - (Optional) Specify the port speed of the specified ports .
auto - Set port speed to auto negotiation.
capability_advertised - (Optional) Specify that the capability will be advertised.
10_half - (Optional) Set port speed to 10_half.
10_full - (Optional) Set port speed to 10_full.
100_half - (Optional) Set port speed to 100_half.
100_full - (Optional) Set port speed to 100_full.
1000_full - (Optional) Set port speed to 1000_full.
10_half - Set port speed to 10_half.
10_full - Set port speed to 10_full.
100_half - Set port speed to 100_half.
100_full - Set port speed to 100_full.
1000_full - Set port speed to 1000_full. While set port speed to 1000_full. User should specify
master or slave mode for 1000BASE-T interface, and leave the 1000_full without any
master or slave setting for other interface.
master - Specify that the port(s) will be set to master.
slave - Specify that the port(s) will be set to slave.
auto_negotiation - Specify to configure the auto-negotiation method.
restart_an - Specify to restart auto-negotiation process.
remote_fault_advertised – Specify that the fault conditions will be remotely advertised when
the next auto-negotiation process takes place.
disable - Remote fault advertisement is disabled.
offline - Local devices that were powered off or removed from the active configuration will
be advertised at the next auto-negotiation.
link_fault - Local devices that disconnected due to link failure will be advertised at the next
auto-negotiation.
auto_negotiation_error - The resolution that precludes operation between local devices
and link partners will be advertised at the next auto-negotiation.
flow_control - (Optional) You can turn on or turn off flow control on one or more ports. By set
flow_control to enable or disable.
enable - Specify that the flow control option will be enabled.
disable - Specify that the flow control option will be disabled.
learning - (Optional) You can turn on or turn off MAC address learning on one or more ports.
enable - Specify that the learning option will be enabled.
disable - Specify that the learning option will be disabled.
state - (Optional) Enables or disables the specified port. If the specificed ports are in error-
disabled status , configure their state to enable will recover these ports from disabled to
enable state.
enable - Specify that the port state will be enabled.
disable - Specify that the port state will be disabled.
mdix - (Optional) The MDIX mode can be specified as auto, normal, and cross. If set to the
normal state, the port is in the MDIX mode and can be connected to PC NIC using a straight
cable. If set to cross state, the port is in mdi mode, and can be connected to a port (in mdix
mode) on another switch thru a straight cable.
auto - Specify that the MDIX mode for the port will be set to auto.
normal - Specify that the MDIX mode for the port will be set to normal.
cross - Specify that the MDIX mode for the port will be set to cross.
description - (Optional) Specify the description of the port interface.
<desc 1-32> - Enter the port interface description here. This value can be up to 32 characters
long.
clear_description - (Optional) Specify that the description field will be cleared.
20