Table of Contents
Advertisement
Note:
Firmware cards designed for
other printers may not work with your
printer.
Warning!
Firmware cards are easily
damaged by static electricity. Touch
something metal on the printer before
you touch a card.
Pins
System board holes
Installing a
firmware card
Follow the instructions in this section to
install a firmware card.
If an option card has been installed, you
must remove it before installing the
firmware card.
If your printer is a network internet
model, an ImageQuick™ firmware card
is already installed.
1
Remove the system board access
cover (see page 22).
2
Unpack the firmware card.
Avoid touching the metal pins on
the bottom of the card. Save the
packaging.
3
Holding the card by its sides, align
the pins on the card with the holes
on the system board.
4
Push the firmware card firmly into
place.
The entire length of the connector
on the firmware card must touch
the system board.
Be careful not to damage the
card's connectors.
Install memory and option cards
25
Advertisement
Table of Contents
