Parking Continuous Forms - IBM 4247 A00 User Manual

Figure 15. Program Configuration Printout
After printing the Program Configuration, the display returns to PRINT OUT=NO. Press
Menu/Enter twice to exit configuration mode.

Parking Continuous Forms

Parking forms means that a forms type unloads from the print area, but still remains
on the tractors. When the forms in one forms path are parked, another forms path
or the Manual Sheet Feed can be selected, and the forms in that path will be
loaded in the print area. This can be configured to occur automatically, but you must
have performed the tear off. See "Checking and Adjusting Tear-Off Position" on
page 25.
Note: For successful forms parking, the top of the input forms stack must be lower
To park a forms type, follow these steps:
1. Press Tear. Tear off the forms at the top cover tear line.
2. Press Park and the message 94 PARK:SURE? displays.
3. Press Park immediately again to park the form.
than bottom of the printer. See Figure 12 on page 20.
Note: If you set TEAR=NO, tear off the forms at the forms-input side of the
printer. When you press the Park key, the message 92 EJECT:SURE?
displays. Press PARK to eject the forms.
29
Chapter 1. Printer Setup