Automatic Carriage Return On Line Feed; Automatic Line Feed On Carriage Return - IBM 4247 A00 User Manual

1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
until the message PARALLEL INTF displays.
4. Press
until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
5. Press
be CX PARALLEL, 1284 BYTE, or 1284 NIBBLE.
until the message LANG=xxxxxxxx displays, where xxxxxxxx can be
6. Press
CP437 through CP1098 when emulation is set Native 4247, 4202 III XL, or 2381
or where xxxxxxxx can be USA through CP1098 when emulation is set to Epson
FX. If you want to select a value other than the one displayed, press
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.

Automatic Carriage Return on Line Feed

You can set the printer to perform an automatic carriage return at a line feed. You
can set this value to:
No (default) No automatic carriage return is performed at a line feed.
Yes An automatic carriage return is performed after a line feed.
To change or check the Automatic Carriage Return after Line Feed:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
until the message PARALLEL INTF displays.
4. Press
until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
5. Press
be CX PARALLEL, 1284 BYTE, or 1284 NIBBLE.
until the message AUTO CR=xxx displays, where xxx can be NO or YES. If
6. Press
you want to select a value other than the one displayed, press
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.

Automatic Line Feed on Carriage Return

You can set the printer to perform an automatic line feed at a carriage return. You
can set this value to:
No (default) No line feed is performed after a carriage return.
Yes An automatic line feed is performed after a carriage return.
Host (Epson FX only)
Host will determine whether an automatic line feed is performed
after a carriage return.
To change or check the Automatic Line Feed on Carriage Return:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
or .
Chapter 4. Configuring Your Printer
or .
89