Ip Ospf Authentication-Key - Enterasys SECURESTACK C3 Configuration Manual

Parameters
seconds
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to set the dead interval to 20 for the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip ospf dead-interval 20

ip ospf authentication-key

Use this command to assign a password to be used by neighboring routers using OSPF's simple
password authentication.The no form of this command removes an OSPF authentication
password on an interface.
Syntax
ip ospf authentication-key password
no ip ospf authentication-key
Parameters
password
Defaults
None.
Mode
Interface configuration: C3
Usage
This password is used as a "key" that is inserted directly into the OSPF header in routing protocol
packets. A separate password can be assigned to each OSPF network on a per‐interface basis.
All neighboring routers on the same network must have the same password configured to be able
to exchange OSPF information.
Specifies the number of seconds that a router must wait to receive a hello
packet before declaring the neighbor as "dead" and removing it from the
OSPF neighbor list. Dead interval must be the same on neighboring routers
(on a specific subnet), but can vary between subnets. This parameter is an
unsigned integer ranging from 1 to 65535. Default value is 40 seconds.
(su)‐>router(Config‐if(Vlan 1))#
Specifies an OSPF authentication password. Valid values are alphanumeric
strings up to 8 characters in length.
(su)‐>router(Config‐if(Vlan 1))#
ip ospf authentication-key
SecureStack C3 Configuration Guide 20-19