Omron CP1H CPU Operation Manual page 744

Connections to Serial Communications Option Boards
5. Wrap adhesive tape around the conductor from which the braided shield was removed.
Soldering
1. Thread a heat-shrinking tube through each conductor.
2. Temporarily solder each conductor to the corresponding connector terminals.
3. Completely solder each conductor.
1 mm
Heat-shrinking tube
Inside diameter:
1.5 mm, l = 10
4. Return the heat-shrinking tube to the soldered portion, then heat the tube to shrink it in place.
Assembling Connector Hood
Assemble the connector hood as shown below.
End connected to FG
Grounding plate
710
Adhesive tape
Soldering iron
Heat-shrinking tube
End not connected to FG
Aluminum foil tape
Appendix F