Omron CP1H CPU Operation Manual page 578

Web Browser Setup and Display
9-10-3 System
System Format
Item
IP Address
Subnet Mask
FINS Node Address
FINS/UDP Port
FINS/TCP Port
Use Input Port No.
Address Conversion
Mode
FINS/UDP Option
544
Set the local IP address for the Ethernet Option Board.
• Setting range: 00.00.00.00 to 223.255.255.255
Set the subnet mask for the Ethernet Option Board.
This is required if a method other than the IP address table method is
used for address conversion.
Set the local FINS node address for the Ethernet Option Board.
• Setting range: 1 to 254
Specify the local UDP port number to be used for the FINS communica-
tions service. The UDP port number is the number used for UDP identi-
fication of the application layer (i.e., FINS communications service).
• Setting range: 1 to 65,535
Specify the local TCP port number to be used for the FINS communica-
tions service. The TCP port number is the number used for TCP identifi-
cation of the application layer (i.e., the FINS communications service in
this case).
• Setting range: 1 to 65,535
Note Make the settings so that TCP port number 80 for HTTP does not
overlap.
The port number setting only has an effect on the FINS/TCP
server function, not on the FINS/TCP client function. FINS/TCP
client port will switch from 3000 to 65535 automatically for con-
nection.
Check this checkbox, if you want the user defined port number for UDP
or TCP to be in effect.
Select any of the following as the method for finding and converting IP
addresses from FINS node addresses. (Enabled for FINS/UDP only.)
• Auto (dynamic): Automatic generation (dynamic)
• Auto (static): Automatic generation (static)
• Manual: IP address table method
• Auto & Manual: Combined method
Select to dynamically change the remote (destination) IP address for
FINS/UDP or not. To prohibit dynamic changes, check the second box.
Contents
Section 9-10
Default
192.168.250.1
255.255.255.0
1
9,600
9,600
Unchecked
Auto (dynamic)
Change
dynamically